Idea for building the base

chang · 05-22-2006, 03:53 PM

I was thinking of attaching the cradle to the midpoint of the shaft and using the shortest rods, effectively appling the strech only to the base section. I think this would be great for focusing on base girth and targeting the ligs. This could be worked in with the overall conventional stretch from behind the glans. Maybe for example 3 hours of "conventional" stretch, then finishing with 1 hour of mid-shaft postion to target the base... Any thoughts on this?

Überschwanz · 05-22-2006, 03:59 PM

It could work. The problem I think you would have with it is that if you stretch the entire penis you will get equal tension along its entire length, but I'm not sure what it might do if you only stretch near the base. Either way, the tension near the base can and should be exactly the same regardless of where you place the strap. It's just the way physics works. You can have a tension of 5 pounds at the base whether you put the strap in the middle of the penis or at the end.

JonPop · 05-22-2006, 05:13 PM

Quote:

Originally Posted by chang

I was thinking of attaching the cradle to the midpoint of the shaft and using the shortest rods, effectively appling the strech only to the base section. I think this would be great for focusing on base girth and targeting the ligs. This could be worked in with the overall conventional stretch from behind the glans. Maybe for example 3 hours of "conventional" stretch, then finishing with 1 hour of mid-shaft postion to target the base... Any thoughts on this?

How would you keep the cradle from sliding? The glans is what holds the cradle and gives you the stretch. How would you fasten it to mid-shaft?
You want to work on the base girth? Do the 3-part dry Jelqs.

chang · 05-22-2006, 05:24 PM

I have been using the cradle very low already (about 1 inch below the glans), and at low to medium tensions I havent had any slipping. I have been using it without the "comfort wraps" because I find them not very comfortable when up against the bottom of the glans, but further down, they are fine, and seem to offer more grip.

I think that the extra grip from the silicone wraps along with lower tension will keep it from slipping. My idea is to go at medium to high tension for the first three hours in the high position (right below the glans) without the silicone wrap, then low to medium tension at mid shaft for an hour to finish.

I warm up with a hot shower, manual stretching, 2 sets of 50 PJs, I dry off then do the 3 part dry jelqs, then do the PM. This midshaft postion would be to finish off the PM session and target the base, after whcih I warm down with another short hot shower.

I'll let you all know how it goes in practice...

JonPop · 05-22-2006, 05:33 PM

Yes! Please keep us informed. This is a novel idea.

chang · 05-29-2006, 09:21 PM

Well, it works in that when strapped in to a clean and dry penis, it pulls from closer to the base puting all the force on that area, and I havent had any slippage. So in theory it should work, but there is no real way of knowing right now what the effect is. Too early to tell, maybe in a few months time...

I have found another good excercise while using the PM: laying on my back with the PM at 12 o'clock and the screws out, I kegel repeatedly, trying to raise my penis up. This is like weightlifting, with the added weight of the PM device, and if you tighten the screws, it adds more resistance. I feel a good burn in the muscles, and a good stretch too. Anyone else tried this?

JonPop · 05-29-2006, 10:38 PM

Yeah, but I do this standing up. Kegel hard and get that puppy bouncing.