Using the pm device

Dav123 · 11-21-2006, 08:40 PM

hi i just started using the pm device but i have a slight problem. When i'm adjusting the traction on my device, up to the 460g mark the rods seem to go into the base rods just fine, however when i try to apply 690g of traction( the third marking) the base rods just spring back up. Is this due to me using the smallest rods available as i've just started? Do i need to using the larger rods in order to stop the traction rods springing up?

Thanks for your help

Überschwanz · 11-22-2006, 03:25 AM

What do you mean by "springing up"?

Dav123 · 11-22-2006, 10:58 PM

well, when i apply more tension on the device the markings should press into the base rods, but at a certain point when more tension is applied the marking come back up, hence giving an inaccurate measurement of tension, can you help with this problem.

Überschwanz · 11-23-2006, 05:13 PM

Quote:

Originally Posted by Dav123

well, when i apply more tension on the device the markings should press into the base rods, but at a certain point when more tension is applied the marking come back up, hence giving an inaccurate measurement of tension, can you help with this problem.

It sounds to me like the resting surface is popping off the rods and the rods are sliding backwards in it. Is this true?

Dav123 · 11-26-2006, 02:36 AM

yeah i think your spot on, do you have a solution to this problem? Your help would be much appriciated.

Überschwanz · 11-26-2006, 11:10 PM

Quote:

Originally Posted by Dav123

yeah i think your spot on, do you have a solution to this problem? Your help would be much appriciated.

Unfortunately no I don't. It's possible you have a defective resting surface. That certainly shouldn't happen.

want8 · 11-27-2006, 07:22 PM

It may be that you don't have the straps tight enough on the resting surface, therefore the penis may be slipping out when you tighten the tention rods. Try to tighten the straps a little, but be careful. You don't want to get them to tight and cut off circulation.